12V 3A AC/DC Power Adapter

$ 25.99 USD

  • Universal Input 90 to 264 VAC
  • EMI Meets FCC/CISPR 22 Class B
  • RoHS Compliant
  • No Land Input Power Consumption Less than 0.075 Watt at 115VAC & 230 VAC Input
  • DoE Efficiency Level VI & COCV5 Tier2
  • Department of Energy 10 CFR Part 430
  • ERP Directive 2009/125/EC

99 in stock

SKU: 835U3 Categories: , Tags: , ,

Works with All U.S. and Canada wireless carriers


12V 3A AC/DC Power Adapter

Compatible with the VOLTEX 50 RV PLUS and VOLTEX 50 YACHT PLUS.

Additional information

Weight 0.5 lbs
Dimensions 1 × 1 × 1 in


Input Specifications

Input Voltage Range 90~264 VAC
Input Frequency 47~63Hz
Inrush Current 150A Max.(Cold Start)

General Specifications

Hold-up Time 6mS typ.
Leakage Current 0.25mA max.
Short Circuit Protection Continuous
Continuous Output Power 36W max.
Hi-pot Isolation : Input / Output 4242 Vdc

Environmental Specifications

Operating Temperature 0℃ ~ 50℃
Derating 40℃ ~ 50℃ 2%/℃
Storage Temperature -40℃ ~ +85℃
Humidity, Non-Condensing 0 to 95% RH
Cooling Free-Air Convection

Output Specifications

Model Number Output Voltage (Volts) Output Current (Amps) Max. Power (Watt) Average Efficiency Limit (min.) 10% Load Efficiency Limit (min.) Ripple P-P (mV) Total Regulation
Min. Rated
835U3 12 0 3.0 36 88.303 % 78.303 % 200 ±5 %


  1.  The minimum average efficiency required by Energy star EPS 2.0 level V & ERP Directive 2009/125/EC stage II in active mode.
    Testing procedure : (heat steady product)
    Set the output at 25%, 50%, 75% and 100% of full rated load and nominal input voltage 115Vdc/230Vac) condition. The minimum four point average efficiency in active mode, express in percent is average efficiency.
  2. Add a 0.1uF ceramic capacitor and a 47uF E.L. capacitor to the output cable. Peak to peak and RMS metering equipment shall have a 20MHz response with probes and cables maintaining frequency response from 200Hz to 100MHz bandwidth. Output ripple and spikes are measured directly at the output terminals of the power supply without the use of the probe ground clip.
  3. Total regulation is defined as the static output regulation at 25℃, including initial tolerance, line voltage and load current within stated limits.


There are no reviews yet.

Be the first to review “12V 3A AC/DC Power Adapter”

Your email address will not be published. Required fields are marked *

Q. What is the cellular signal booster?
A. The cellular signal booster is a product that boosts your cell phone reception and data service.

Q. Why need to use a cellular signal booster?
A. Cellular signals may not be sufficient if your cellular is located far away from the cell.

Q. Do I need an internet connection to use a cellular signal booster?
A. Cell phone signal booster doesn’t need to connect the internet.

Q. Do I have to pay a monthly fee to use the cellular signal booster?
A. You don’t need to pay a monthly fee.

Q. Where is the best position to install the outside antenna?
A. Best position is the roof of a building or house without any obstructions. If it can not be installed outside, it is recommended to be as close as the outside as possible.

Q. Even after installing the booster, the cellular reception is still weak. What Can I do?
A. Check the power source is connected to the booster. Make sure the outside antenna and inside antenna is sufficiently separated.